Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 500

System board and components
▶ Locate the slotted lower end of the TPM screw (1).
▶ Carefully loosen the TPM screw using a thin slotted screwdriver (e.g.
watchmaker's screwdriver) or the dedicated TPM screwdriver (Japan) (2).
CAUTION
▶
Ensure to turn the screw clockwise in order to remove it.
▶
Slowly and carefully increase the pressure on the screw until it
begins to turn. The effort when loosing the screw should be as
low as possible.
Otherwise the thin metal bar may break, rendering it impossible
to loosen the screw.
▶ Remove the TPM screw (3).
▶ Remove the TPM on the upper side of the system board.
Figure 340: Removing the TPM spacer
▶ Using a flat nose pliers, press together the hooks on the TPM spacer (1, see
close-up) and remove it from the system board (2).
If the TPM is to be replaced, the TPM spacer may remain on the
system board.
▶ Install the system board, see
page 518.
500
"Installing the new system board" on
Upgrade and Maintenance Manual RX2540 M7