Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 514

System board and components
▶ For a system with air cooling, proceed as follows:
▶
"Removing the air duct" on page
▶ Remove all memory modules, see
page 344.
Before removing the memory modules, take a note on the
installation slot number for each memory module. Ensure that you
reinstall the memory modules in the slot they were located before
the replacement.
▶ If applicable, remove all dummy memory modules, see
memory dummy module" on page
▶ Remove all riser modules, see
▶
"Removing the fan cage" on page
▶
"Removing the crossbar" on page
▶ If applicable, remove all expansion cards, see
card" on page 278.
▶ Remove the iRMC microSD card, see
on page 506.
Removing the defective system board
▶ Disconnect all cables from the system board.
514
80.
"Removing memory modules" on
347.
"Removing a riser module" on page
76.
83.
"Removing the iRMC microSD card"
Upgrade and Maintenance Manual
"Removing a
"Removing an expansion
72.
RX2540 M7