Connecting The Power Cord; Connecting The Power Cord (Ac Psu) - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

4.7

Connecting the power cord

4.7.1

Connecting the power cord (AC PSU)

CAUTION
The AC PSU adjusts automatically to any mains voltage in the range
from 100 V - 240 V (AC PSU Platinum) or 200 V - 240 V (AC PSU
Titanium).
▶
You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
▶ Connect the power cord to the PSU.
▶ If applicable, connect the main plug to an power outlet of the rack socket
strip.
To provide true phase redundancy, the second PSU should be
connected to a different AC power source from the other PSU. If one
AC power source should fail, the server will still continue to run.
▶ Ensure that the status indicator on the PSU is lit green, see
hot-plug PSU" on page
It will take about 60 seconds until the server can be powered on.
You can secure the power cord with a cable clamp or a hook-and-loop
tape to ensure that the power cord cannot be disconnected from the
server by mistake.
RX2540 M7
553.
Upgrade and Maintenance Manual
Basic hardware procedures
"Indicator on
65