Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 302

Expansion cards and backup units
Figure 173: Connecting cables to the system board
▶ Connect the following cables:
1 Slim SAS cable to connector "MCIO2" on the system board
2 Slim SAS cable to connector "MCIO1" on the system board
3 Power cable to connector "PWR 1" on the system board
The cables are equipped with labels showing the right connector.
For the cable plan, see
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
302
"Appendix B" on page
Upgrade and Maintenance Manual
1
2
559.
3
RX2540 M7