Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 509

▶ Proceed the steps in the recovery guidelines, see
recovery guidelines after replacing an iRMC microSD card" on page 509
and "BIOS recovery guidelines after replacing an iRMC microSD card" on
page 509.
Concluding steps
▶ If applicable, install the expansion card in slot 5 and 6, see
expansion card" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶ Verify that the iRMC S6 recognizes the installed iRMC microSD card.
▶ Wait until the firmware restore is completed. BIOS or iRMC S6 firmware
restore feature is executed at the same time as the power cord is connected
after the iRMC microSD card replacement.
▶ If applicable,
"Installing the front cover with lock" on page
iRMC S6 firmware recovery guidelines after replacing an iRMC microSD
card
▶ After replacing the iRMC microSD card and starting up the iRMC S6
firmware, confirm that the iRMC microSD card backup completion message
in the iRMC S6 firmware is registered in the SEL.
<iRMC>
A backup of iRMC Firmware%1 has been successfully created
on SD card.
BIOS recovery guidelines after replacing an iRMC microSD card
Perform the following steps after replacing the iRMC microSD card on systems
with and without the ServerView related tools.
RX2540 M7
269.
59.
65.
Upgrade and Maintenance Manual
System board and components
"iRMC S6 firmware
"Installing an
71.
509