Removing An Expansion Card From A Riser Module - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
▶ If applicable, update the system information of your server using the Chassis
ID Prom Tool, see
▶
"Updating expansion card firmware" on page
▶
"Resuming BitLocker functionality" on page
9.9.2

Removing an expansion card from a riser module

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the corresponding riser module, see
page 72.
Removing the expansion card from a riser module
▶ If necessary, disconnect the cables from the expansion card.
▶ If applicable,
"Removing SFP+ transceiver modules" on page
RX2540 M7
71.
"Using the Chassis ID Prom Tool" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
98.
107.
Hardware: 5 minutes
Software: 5 minutes
89.
50.
50.
55.
"Removing a riser module" on
71.
113.
49.
258.
313