Replacing The Irmc Microsd Card - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

▶ To eject the iRMC microSD card, gently push it in and then let go (1).
▶ Pull the iRMC microSD card straight out of its slot (2).
CAUTION
(not valid for Europe, Middle East, India and Africa)
The iRMC microSD card contains customer information.
▶
After removing the iRMC microSD card, hand the card over to
the customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
Concluding steps
▶ If applicable, install the expansion card in slot 5 and 6, see
expansion card" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
17.5.4

Replacing the iRMC microSD card

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (for cover 2)
Note on BIOS or iRMC S6 firmware restore feature
iRMC S6 firmware restore feature is executed at the same time as the power
cord is connected after the iRMC microSD card replacement.
RX2540 M7
269.
59.
65.
71.
Upgrade and Maintenance Manual
System board and components
"Installing an
71.
Hardware: 5 minutes
Software: 20 minutes
(Firmware restore:
depending on configuration)
507