Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 182

Hard disk drive (HDD) / solid state disk (SSD)
▶ Pull the HDD/SSD module completely out of its bay.
Installing a 2.5-inch HDD/SSD dummy module
CAUTION
▶
If the removed HDD/SSD module is not replaced immediately,
always replace a dummy module into the unused HDD/SSD bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Figure 82: Installing the 2.5-inch HDD/SSD dummy module
▶ Push the dummy module into the empty bay until it engages.
▶ If applicable, insert the dummy lock.
Concluding steps
▶ If applicable,
"Installing the front cover with lock" on page
182 Upgrade and Maintenance Manual
71.
RX2540 M7