Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual page 298

Expansion cards and backup units
Installing the internal RAID riser module
Figure 169: Connecting cables to the internal RAID riser module
▶ Connect the following cables to the internal RAID riser module:
1 HDD LED cable
2 SLIM SAS cable, depending on configuration
3 SLIM SAS cable, depending on configuration
4 Power cable
The cables are equipped with labels showing the right connector.
For the cable plan, see
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
298
"Appendix B" on page
Upgrade and Maintenance Manual
559.
RX2540 M7