Hard disk drive (HDD) / solid state disk (SSD)
Upgrade and Repair Unit
(URU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Removing the fan cage" on page
Removing the defective SAS expander board
▶ Disconnect all cables from the SAS expander board.
▶ Remove the SAS expander board, see
board" on page
Installing the new SAS expander board
▶ Install the SAS expander board, see
page
202.
▶ Connect the cables to the SAS expander board, see
Concluding steps
▶
"Installing the fan cage" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ Verify that the iRMC S6 recognizes the installed HDDs/SSDs.
210
207.
77.
59.
Upgrade and Maintenance Manual
Hardware: 10 minutes
47.
50.
50.
55.
76.
"Removing the SAS expander
"Installing the SAS expander board" on
65.
71.
49.
Figure
103.
RX2540 M7