Toshiba DP120F Service Manual page 490

2.4.9 Paper Pickup Roller Assembly (Bypass Tray)
Before disassembling or reassembling, be sure to refer to "1. Before Disassembling or Reas-
sembling."
(1) Remove the rear cover. (Refer to "2.1.5 Rear Cover.")
(2) Remove the front cover assembly. (Refer to "2.1.6 Front Cover.")
(3) Remove the right side cover. (Refer to "2.1.7 Right Side Cover.")
(4) Remove the inner cover. (Refer to "2.1.13 Inner Cover.")
(5) Remove the paper pickup solenoid. (Refer to "2.4.7 Paper Pickup Solenoid (Bypass Tray).")
(6) Remove the printer frame right assembly. (Refer to "2.4.8 Printer Frame Right Assembly.")
(7) Rotate the bushings on the sides of the paper pickup roller assembly until they can be
released from the guide of the side frames. Then, remove the paper pickup roller assem-
bly.
(8) Reassemble the components in the reverse order of disassembly.
NOTE: • When installing the paper pickup solenoid, perform the paper pickup sole-
noid gap adjustment referring to the "3.1 Paper Pickup Solenoid Gap" on
page 8-130.
• After reassembling, load a document and press the [COPY] key. Confirm
that feeding normally operate from the bypass tray.
DP120F/DP125F Removal/Replacement
Paper pickup roller assembly
Fig. 8-2-88
8-70
Bushing
08-02-88
March 2000 © TOSHIBA TEC