Toshiba DP120F Service Manual page 571

2.2.2 Binary Signals
NSF Non-Standard Facility
Informs that the receiving station (machine) has a non-standard facility (i.e., HS/
ECM, etc.).
NSC Non-Standard Facility Command
Commands to transmit with the non-standard facility which is selected corre-
sponding to NSF (i.e., Polling etc.).
NSS Non-Standard Facility Set-up
Commands to transmit with the non-standard facility which is selected corre-
sponding to NSF or NSC.
CSI Called Station Identification
Provides the telephone number of the called station. Used to check the identity
of the called station.
CIG Calling Station Identification
Provides the telephone number of the calling station. Used to check the identity
of the calling station (Polling, etc.).
TSI Transmitting Station Identification
Provides the telephone number of transmitting station. Used to check the iden-
tity of the transmission station.
DIS Digital Identification Signal
Informs that the receiving station (machine) has a standard facility (G3/G2).
DTC Digital Transmit Command
Commands to transmit with the standard facility which is selected correspond-
ing to DIS (i.e., Polling, etc.).
DCS Digital Command Signal
Commands to transmit with the standard facility which is selected correspond-
ing to DIS or DTC.
CFR Confirmation to Receive
Informs that the facsimile is in the receivable status.
FTT Failure to Train
Informs that the TCF signal has not received correctly and requests re-training.
EOM End of Message
Informs that a document has been transmitted and another document is loaded;
commands to return to the beginning of phase B.
MPS Multi-page Signal
Informs that a document has been transmitted and another document is loaded;
commands to return to the beginning of phase C.
EOP End of Procedure
Informs that a document has been transmitted and no additional documents are
loaded.
March 2000 © TOSHIBA TEC 9-7 DP120F/DP125F Dialing and Communication Procedure