Umr1N Field Descriptions - Motorola ColdFire MCF5281 User Manual

Motorola microcontroller user's manual
Table of Contents

Advertisement

Table 23-2 describes UMR1n fields.
Bits
Name
7
RxRTS Receiver request-to-send. Allows the RTS output to control the CTS input of the transmitting device to prevent
receiver overrun. If both the receiver and transmitter are incorrectly programmed for RTS control, RTS control
is disabled for both. Transmitter RTS control is configured in UMR2n[TxRTS].
0 The receiver has no effect on RTS.
1 When a valid start bit is received, RTS is negated if the UART's FIFO is full. RTS is reasserted when the FIFO
has an empty position available.
6
RxIRQ/
Receiver interrupt select.
FFULL
0 RxRDY is the source that generates IRQ or DMA request.
1 FFULL is the source that generates IRQ or DMA request.
5
ERR
Error mode. Configures the FIFO status bits, USRn[RB,FE,PE].
0 Character mode. The USRn values reflect the status of the character at the top of the FIFO. ERR must be 0 for
correct A/D flag information when in multidrop mode.
1 Block mode. The USRn values are the logical OR of the status for all characters reaching the top of the FIFO
since the last
Command Registers (UCRn)."
4–3
PM
Parity mode. Selects the parity or multidrop mode for the channel. The parity bit is added to the transmitted
character, and the receiver performs a parity check on incoming data. The value of PM affects PT, as shown
below.
2
PT
Parity type. PM and PT together select parity type (PM = 0x) or determine whether a data or address character is
transmitted (PM = 11).
1–0
B/C
Bits per character. Select the number of data bits per character to be sent. The values shown do not include start,
parity, or stop bits.
00 5 bits
01 6 bits
10 7 bits
11 8 bits
MOTOROLA
Table 23-2. UMR1n Field Descriptions
command for the channel was issued. See Section 23.3.5, "UART
RESET ERROR STATUS
PM
Parity Mode
00
With parity
01
Force parity
10
No parity
11
Multidrop mode
Chapter 23. UART Modules
Description
Parity Type (PT= 0)
Even parity
Low parity
High parity
n/a
Data character
Register Descriptions
Parity Type (PT= 1)
Odd parity
Address character
23-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Coldfire mcf5282

Table of Contents