Table of Contents
Advertisement
Revision History
Revision
Date of
Number
Release
lvi
Table iii. Revision History
Substantive Changes
Changed pull-up indications in the 'Internal Pull-Up' column.
Change encodings for bits 31–9 to:
0 The corresponding interrupt source is masked.
1 The corresponding interrupt source is not masked.
Change PIT1–PIT4 to PIT0–PIT3 throughout chapter. When a timer is
referenced individually, PIT1 should be PIT0, PIT2 should be PIT1, PIT3
should be PIT2, and PIT4 should be PIT3. Other chapters in the user's manual
use the correct nomenclature: PIT0–PIT3.
Change timeout period equation to the equation below.
Timeout period
Change UISR bits 5–3 to reserved bits
Change 'I2CR = 0xA' to 'I2CR = 0xA0.'
Changed 'When interfacing to 16-bit ports, the port C and D pins and PJ[5:4]
(BS[1:0]) can be configured as general-purpose input/output (I/O)'
Added additional device number order information to Table 32-2 for
MCF5280 and MCF5281 at 66- and 80-MHz, and MCF5282 at 80 MHz.
Delete references to 'T
= T
A
L
Replace V
row with the row below, in which the maximum value has been
in
changed to 6.0 V.
Replace I
row with the row below, in which the maximum value in
DDA
normal operation has been changed to 5.0 mA.
Replaced Figure 33-5, "SDRAM Read Cycle"
MCF5282 User's Manual
×
PRE[3:0] (PM[15:0]
+
1)
=
-----------------------------------------------------------------------------
system clock
to T
'.
H
Section/Page
Table 14-3/14-11
Table 17-13/17-26
Chapter 19
19.6.3/19-7
×
2
Figure 23-11/23-13
24.6.1/24-10
30.2.1/30-2
Table 32-2/32-7
Chapter 33
Table 33-1/33-1
Table 33-6/33-7
Figure 33-5/33-16
MOTOROLA
Advertisement
Table of Contents
