Wlan Interface Configuration Mode; Wlan Ipcf - Siemens SIMATIC NET Configuration Manual

Syntax
Call up the command with the following parameters:
show wlan ipcf <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The iPCF settings are displayed.
4.3.2

WLAN Interface Configuration mode

This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
mode.
● If you exit the WLAN Interface Configuration mode with the
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the
the Privileged EXEC mode.
4.3.2.1

wlan ipcf

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
With this command, you enable the iPCF mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
WLAN interface
Functions specific to SCALANCE
Range of values / note
Enter a valid interface.
command to change to this
interface wlan 0/X
exit
end
4.3 iPCF
command, you return to
command, you return to
101