Show Lldp Status; Show Versions - Siemens SIMATIC NET Configuration Manual

3.1.1.12

show lldp status

Description
This command shows per port whether LLDP frames are sent or received.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show lldp status[{port <interface-type> <interface-id>}]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on identifiers of interfaces and addresses, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The information is displayed.
3.1.1.13

show versions

Description
This command shows the versions of the hardware and software of the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
or
cli#
Description
Keyword for a port description.
Type or speed of the interface
Module no. and port no. of the interface
or
cli#
Configuration
3.1 System
Range of values/note
-
Enter a valid interface.
43