Commands In The Interface Configuration Mode - Siemens SIMATIC NET Configuration Manual

Network structures
6.3 Spanning Tree
Syntax
Call up the command with the following parameters:
no spanning-tree{forward-time|hello-time|max-age}
The parameters have the following meaning:
Parameter
forward-time
hello-time
max-age
Result
The selected setting for the time is reset to the default value.
Further notes
You configure the time with the
You display these settings and other information with the commands that start with
spanning tree ...
6.3.4

Commands in the interface configuration mode

This section describes commands that you can call up in the Interface configuration mode.
Note
The commands are only available with layer 3 and when the interface is a VLAN interface.
In the VRRP Router configuration mode, enter the
mode.
Commands relating to other topics that can be called in the Interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
VRRP Router configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
Requirements for changing to this mode:
● MSTP is enabled
● Base bridge mode: 802.1Q VLAN Bridge
● Compatibility mode: MSTP
264
Description
Time after which a port changes its spanning tree status from "Blocking" to
"Forwarding"
Time after which the bridge sends its configuration frames (BPDUs)
Time after which the information of the BPDUs becomes invalid
spanning-tree
.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
command (time settings).
command to change to this
interface
command, you return to the
exit
command, you return to the
end
Configuration Manual, 10/2015, C79000-G8976-C351-05
show