Commands In The Global Configuration Mode; Snmpagent; No Snmpagent - Siemens SIMATIC NET Configuration Manual

7.4.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
7.4.2.1

snmpagent

Description
With this command, you enable the SNMP agent function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
snmpagent
Result
The SNMP agent function is enabled.
Further notes
You disable the SNMP agent function with the
7.4.2.2

no snmpagent

Description
With this command, you disable the SNMP agent function.
Requirement
You are in the Global configuration mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command to change to this mode.
configure terminal
or
end exit
no snmpagent
Network protocols
command and are then in the
command.
7.4 SNMP
331