Network Protocols; Ipv4 Protocol; The "Show" Commands; Show Dcp Forwarding - Siemens SIMATIC NET Configuration Manual

Network protocols

This part contains the sections that describe the commands for working with the various
network protocols.
7.1

IPv4 protocol

This section describes commands of the Internet Protocol (IP) version 4.
7.1.1

The "show" commands

This section describes commands with which you display various settings.
With the command
configuration mode.
To do this, you replace
Example
do show cli-console-timeout
7.1.1.1

show dcp forwarding

Description
This command shows an overview of the DCP forwarding behavior on one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
do [command]
[command]
or
cli#
you can execute the "show" commands in every
with the "show" command that you want to execute.
7
281