Spectrum Analyzer; The "Show" Commands; Show Wlan Spectrumanalyzer (Access Point) - Siemens SIMATIC NET Configuration Manual

Functions specific to SCALANCE

4.5 Spectrum analyzer

4.5 Spectrum analyzer
This section describes the commands relevant for working with the spectrum analyzer.
Which the spectrum analyzer you can recognize and represent the electromagnetic signals
of a frequency range. You can measure the strength of all signals located in the environment
of the access point.
4.5.1

The "show" commands

This section describes commands with which general system properties can be displayed
and configured.
4.5.1.1

show wlan spectrumanalyzer (Access Point)

Description
This command shows the settings of the spectrum analyzer.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameter assignment:
show wlan spectrumanalyzer
Result
The settings of the spectrum analyzer are displayed.
108
or
cli#
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05