Show Web-Session-Timeout; Commands In The Global Configuration Mode; Web-Session-Timeout - Siemens SIMATIC NET Configuration Manual

Functions specific to SCALANCE
4.1 WBM
4.1.1.1

show web-session-timeout

Description
This command shows the timeout setting for the WBM.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show web-session-timeout
Result
The timeout setting for the WBM is displayed.
4.1.2

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
4.1.2.1

web-session-timeout

Description
With this command, you enable the automatic logoff and you configure the timeout setting for
the WBM.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
92
or
cli#
command to change to this mode.
configure terminal
or
end exit
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command and are then in the