Mgmt Vlan - Siemens SIMATIC NET Configuration Manual

Network structures
6.2 VLAN
6.2.2.6

mgmt vlan

Description
With this command, you change the agent VLAN ID. You can only use VLANs that have
already been configured.
Note
Changing the agent VLAN ID
If the configuration PC is connected directly to the device via Ethernet and you change the
agent VLAN ID, the device is no longer reachable via Ethernet following the change.
Requirement
● In "
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mgmt vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameters
vlan-id
Result
The Agent VLAN ID has been changed.
Further notes
You reset the
228
", the mode for the device is set to
base bridge-mode
Description
Number of the addressed VLAN
setting with the
dot1q-vlan
dot1q-vlan
command.
base bridge-mode
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Range of values / note
1 ... 4094