Show Wlan Wds-List (Access Point); Show Wlan Ip-Mapping - Siemens SIMATIC NET Configuration Manual

6.1.1.19

show wlan wds-list (access point)

Description
This command shows the WDS partners connected to the WLAN interface.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan wds-list <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The WDS partners of the WLAN interface are displayed.
6.1.1.20

show wlan ip-mapping

Description
This command shows the table for the IP mapping. The table contains the assignment of
MAC address and IP address of the SCALANCE W700 devices for which the client makes
WLAN access possible.
Note
This page is only available for clients or access points in client mode.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
or
cli#
Description
WLAN interface
Range of values / note
Enter a valid interface.
Network structures
6.1 WLAN
149