No Vap Broadcast Ssid (Access Point) - Siemens SIMATIC NET Configuration Manual

Industrial wireless lan to ieee 802.11n command line interface

Hide thumbs Also See for SIMATIC NET:

Table of Contents

Network structures

no vap broadcast ssid (access point)

With this command, you disable the "Broadcast SSID" function. The SSID is no longer sent

in the frame of the access point. This means that the SSID is not visible for other

SCALANCE W700 devices. Only stations that know the SSID of the access point and that

are configured with it can connect to the access point. The "Any SSID" option must be

disabled on these clients.

This command is available only in access point mode.

You are in the Interface Configuration mode of the VAP interface.

The command prompt is as follows:

cli (config-if-vapX-0-Y)#

Call the command without parameter assignment:

no vap broadcast ssid

The function is disabled.

Further notes

You display the setting with the

You enable the function with the

Table of Contents

Scalance w720 Scalance w760