Ip Address Dhcp - Siemens SIMATIC NET Configuration Manual

Result
The assignment of the IP address to a VLAN interface is deleted and DHCP is disabled.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which you access the device, you can lose the connection!
Further notes
You configure the setting with the
You display this setting and other information with the
7.1.3.3

ip address dhcp

Description
With this command, the VLAN interface obtains the IP address via DHCP.
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call the command without parameters:
ip address dhcp
Result
The DHCP assigns the IP address to the VLAN interface.
Further notes
You delete the settings with the
You display this setting and other information with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
ip address
show ip interface
command.
no ip address
show ip interface
Network protocols
7.1 IPv4 protocol
command.
command.
297