Snmp Access - Siemens SIMATIC NET Configuration Manual

7.4.2.4

snmp access

Description
With this command, you configure the access to an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp access <GroupName>{v1|v2c|v3{auth|noauth|priv}}
[read <ReadView|none>][write <WriteView|none>][notify <NotifyView|none>]
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter
GroupName
-
-
read
write
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Name of the group to which access is
configured
Selects the version of the protocol
used
Selects the authentication method:
the data can be read
Keyword
the data can be read and written
Keyword
Network protocols
7.4 SNMP
Range of values / note
max. 32 characters
•
v1
•
v2c
•
v3
•
auth
enables MD5 or SHA as au-
thentication method
•
noauth
no authentication
•
priv
enables authentication and
encryption
•
ReadView
•
none
•
WriteView
•
none
333