No Auto-Save - Siemens SIMATIC NET Configuration Manual

Configuration
3.4 Configuration Save & Restore
You disable the function with the
You can display the status of this function and other information with the
information
3.4.3.2

no auto-save

Description
With this command, you disable the auto save function.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no auto-save
Result
The auto save function is disabled. The Trial mode is activated.
Further notes
You enable the function with the
You can display the status of this function and other information with the
information
You save changes to the configuration in the Trial mode with the
command.
86
no auto-save
command.
auto-save
command.
command.
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
show device
show device
write startupconfig