No Switchport Ingress-Filter; Switchport Priority Default - Siemens SIMATIC NET Configuration Manual

Network structures
6.2 VLAN
6.2.3.5

no switchport ingress-filter

Description
With this command, you disable the ingress filter.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport ingress-filter
Result
The ingress filter is deactivated.
Further notes
You enable the filter with the
You can display the status of the ingress filter and other settings with the
config
6.2.3.6

switchport priority default

Description
With this command, you configure the priority default for the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
232
switchport ingress-filter
command.
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
show vlan port