Show Wlan Client-List (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
Syntax
Call up the command with the following parameters:
show wlan client <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The following client settings are displayed:
● MAC Mode
● Manual MAC Address
● Any SSID
● Roaming Threshold
● Background scan mode
● Background Scan Interval
● Scan Channels
6.1.1.9

show wlan client-list (access point)

Description
This command shows a table with the clients logged on with the access point as well as
additional information, for example status, signal strength, MAC address.
Note
The command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
138
Description
WLAN interface
or
cli#
Range of values / note
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05