Show Ip Dhcp-Server Pools - Siemens SIMATIC NET Configuration Manual

Network protocols
7.3 DHCP server
7.3.1.1

show ip dhcp-server pools

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
• SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-0AA0
and 6GK5761-1FC00-0AB0 (US version))
Description
The command shows the DHCP server configuration of a specific IPv4 address band or all
IPv4 address bands and the corresponding DHCP options.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show ip dhcp-server pools [pool-id (1-5)]
The parameter has the following meaning:
Parameter
pool-id
Result
The configuration of the DHCP server and the DHCP options is displayed.
304
or
cli#
Description
ID of the addressed IPv4 address
band
Range of values / note
1 ... 5
Only ID = 1 is supported.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05