Dcp Forwarding - Siemens SIMATIC NET Configuration Manual

Network protocols
7.1 IPv4 protocol
7.1.3.4

dcp forwarding

Description
With this command, you configure the forwarding behavior of the interface for DCP frames.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
dcp forwarding {block|forward}
The parameters have the following meaning:
Parameter
block
forward
Result
The forwarding behavior of the interface for DCP frames is configured.
298
Description
DCP frames are discarded
DCP frames are forwarded
Default:
forward
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05