No Ip Http - Siemens SIMATIC NET Configuration Manual

Syntax
Call the command without parameters:
ip http
As default the function is "enabled".
Result
HTTP is enabled on the device.
Further notes
You can display the setting of this function and other information with the
server status
You deactivate HTTP on the device with the
7.6.2.2

no ip http

Description
With this command, you disable HTTP on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip http
Result
HTTP is disabled on the device.
Further notes
You can display the setting of this function and other information with the
server status
You enable HTTP with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
command.
command.
ip http
command.
no ip http
Network protocols
7.6 HTTP server
show ip http
show ip http
361