Wds Connection Over (Access Point) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.7.4

wds connection over (access point)

Description
With this command, you specify the VAP interface via which the WDS connection is
established.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode for the WDS interface.
The command prompt is as follows:
cli (config-if-wdsX-0-Y)#
Syntax
Call up the command with the following parameters:
wds conncection over <vapX 0/Y>
The parameter has the following meaning:
Parameter
wdsX 0/Y
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The VAP interface is set.
Further notes
You display the setting with the
216
Description Range of values / note
Interface Enter a valid interface.
show wlan wds <wdsX 0/Y>
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.