Pool-Enable - Siemens SIMATIC NET Configuration Manual

7.3.3.7

pool-enable

Note
The command is only available with the following device:
• SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
• SCALANCE W761-1 RJ45 in access point mode (article number): 6GK5761-1FC00-0AA0
and 6GK5761-1FC00-0AB0 (US version))
Description
With this command you specify that this IPv4 address band will be used.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call the command without parameter assignment:
pool-enable
Result
The setting is enabled.
Note
If the IPv4 address band is enabled, DHCP options (option ...) and static assignments (static
leases) can no loner be edited.
Further notes
You display the setting with the
You disable the setting with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
show ip dhcp-server pools
command.
no pool-enable
Network protocols
7.3 DHCP server
command.
319