No Spanning-Tree - Siemens SIMATIC NET Configuration Manual

Network structures
6.3 Spanning Tree
With this command, you enable the spanning tree function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree
Result
The spanning tree function is enabled.
Further notes
As default the function is "enabled".
You disable the spanning tree function with the
You can display the status of this function and other information with the
detail
You can display information about active ports with the
command.
6.3.3.2

no spanning-tree

Description
With this command, you disable the spanning tree function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree
250
command.
no spanning tree
show spanning tree active
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.
show spanning tree