Tftp Load - Siemens SIMATIC NET Configuration Manual

Configuration
3.2 Load and Save
3.2.5.3

tftp load

Description
With this command, you load a file from a TFTP server into the file system of the device. The
TFTP protocol is used for the transfer. You can also display a list of available files.
Requirement
● The name of the file is specified
● You are in the LOADSAVE configuration mode.
The command prompt is:
cli(config-loadsave)#
Syntax
Call up the command with the following parameters:
tftp load{showfiles|filetype<filetype>}
The parameters have the following meaning:
Parameter
showfiles
filetype
filetype
Result
The file types are displayed or the file is downloaded to the device.
Further notes
You configure the name of the file with the
With the "
76
Description
Shows the available files
Keyword for a file type to be loaded
Name of the file type
" command, you can display the file types.
show loadsave files
Range of values / note
-
-
max. 100 characters
command.
tftp filename
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05