Pre-Assignment Of Inputs/Outputs And Wiring Via P0015 Macros - Siemens Sinamics G120P Operating Instructions Manual

Commissioning

5.2 Pre-assignment of inputs/outputs and wiring via p0015 macros

5.2 Pre-assignment of inputs/outputs and wiring via p0015 macros
Examples for (p0015) I/O preassignments macro
The following examples show the pre-assigned inputs and outputs defined automatically
depending on the macro that is selected during the initial commissioning. Because the
assignments of the inputs and outputs are specific for each Control Unit type, the following
information serves only as example. The inputs and outputs can be configured manually if no
suitable macro for the application can be found.
When selecting the macro, different macro designations are saved in the commissioning
tools (IOP, STARTER), which are juxtaposed in the following table:
Assignment of the macros to the designations in IOP and STARTER
Macro Name in the subsequent section
---
Macro 7 Automatic/local - changeover be-
tween fieldbus and jog mode
Macro 9 Motorized potentiometer
Macro 12 Setpoint via analog input
Macro 14 Process industry
PROFIBUS DP or PROFINET /
MOP fieldbus
Macro 15 Process industry analog setpoint /
MOP
Macro 17 Two-wire control, method 2
Macro 18 Two-wire control, method 3
Macro 19 Three-wire control, method 1
Macro 20 Three-wire control, method 2
Macro 21 Communication with a higher-level
control via USS
Macro 22 Communication with a higher-level
control via CANopen
124
Selection during commissioning via
the IOP
Conveyor with CDS selection
Standard I/O with MOP
Standard I/O with analog setpoint
Process I/O with fieldbus
Process I/O
2-wire (forw/backw1)
2-wire (forw/backw2)
3-wire (enable/forw/backw)
3-wire (enable/start/dir)
USS fieldbus
CAN fieldbus
Selection during commissioning via
STARTER
No change
7.) Fieldbus with data set switch-
over
9.) Standard I/O with MOP
12.) Standard I/O with analog set-
point
14.) Process industry with fieldbus
15.) Process industry
17.) 2-wire (forw/backw1)
18.) 2-wire (forw/backw2)
19.) 3-wire (enable/forw/backw)
20.) 3-wire (enable/on/reverse)
21.) USS fieldbus
22.) CAN fieldbus
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A