Bico Technology: Interconnecting Signals - Siemens Sinamics G120P Operating Instructions Manual

Operation
6.2 Basic information about the drive system
Function diagram
FP 8560
FP 8565
Parameter
• p0170
• p0180
• p0809[0...2]
• p0810
• p0811
• p0819[0...2]
• p0820
• p0821
6.2.3

BICO technology: Interconnecting signals

Description
Every drive contains a large number of interconnectable input and output variables and
internal control variables.
BICO technology (Binector Connector Technology) allows the drive to be adapted to a wide
variety of conditions.
Digital signals, which can be connected freely by means of BICO parameters, are identified
by the prefix BI, BO, CI or CO in their parameter name. These parameters are identified
accordingly in the parameter list or in the function diagrams.
Note
Using STARTER
The STARTER parameterization and commissioning tool is recommended when using BICO
technology.
Binectors, BI: Binector input, BO: Binector output
A binector is a digital (binary) signal without a unit which can assume the value 0 or 1.
Binectors are subdivided into binector inputs (signal sink) and binector outputs (signal
source).
174
Command data sets (CDS)
Drive data sets (DDS)
Number of command data sets (CDS)
Number of drive data sets (DDS)
Copy command data set CDS
BI: Command data set selection CDS bit 0
BI: Command data set selection CDS bit 1
Copy drive data set DDS
BI: Drive data set selection, bit 0
BI: Drive data set selection, bit 1
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A