Parameters - Siemens Sinamics G120P Operating Instructions Manual

Operation
6.10 Operation with the IOP
Drive enable signals
The "Drive enables" screen shows a list of all current enable
signals of the inverter. It will be selected if the enable signal is
available and active (
enable signal is not present and not active ☐.
This is only an information screen in which no changes can be
made.
6.10.4.3

Parameters

"Parameters" menu
Note
IOP function support
• The actual menu structure and the function scope of the IOP depend on the following
factors:
– Type of Control Unit to which the IOP is connected
– Firmware version of the Control Unit
– Firmware version of the IOP
– Selected function group filtering of the parameters
• When parameters or search values are changed, it is possible to change individual digits
or the complete value. Pressing the navigation wheel for a longer time (> 3 seconds)
switches between the two different change modes.
The "Parameters" menu allows you to access all inverter pa-
rameters, and therefore the associated comprehensive func-
tions. When this option is selected, parameter-based functions
are performed.
These are grouped as follows:
• Parameter groups
• Search for number
• My parameters
• Changed parameters
• Parameter filter
316
). The selection will be withdrawn if the
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A