Siemens Sinamics G120P Operating Instructions Manual page 320

Operation
6.10 Operation with the IOP
Diagnostics
When this option is selected, you can access the parameters
for the system status monitoring.
Parameters are subdivided into the following function groups:
• Control/status words
• Drive enable signals
• Faults/alarms
• Interconnections
The parameters in these groups can only be displayed – but
not changed.
Search for number
When this option is selected, you can search for specific pa-
rameter numbers. If the entered parameter number does not
exist, the parameter whose number is nearest to the entered
number is displayed.
Turn the navigation wheel to change the individual digit val-
ues; turn the navigation wheel to confirm the selection. The
next digit is selected automatically. Repeat the process as
described above. Once all fields have been completed, the
IOP shows the parameter. If you have selected a wrong num-
ber, press Esc to go back one position.
If the parameter number does not exist, the screen gives you
a choice between "Enter new number" and "Go to the adja-
cent parameter".
My parameters
When you select this option, you can select the parameters to
be listed. A list with all selectable parameters that specify
those parameters to be displayed with the "My parameters"
option is displayed. There are further options used to manage
this parameter list.
320
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A