Operation
6.10 Operation with the IOP
Note
IOP function support
The actual menu structure and the function scope of the IOP depend on the following
factors:
• Type of Control Unit to which the IOP is connected
• Firmware version of the Control Unit
• Firmware version of the IOP
• Selected function group filtering of the parameters
6.10.4.2
Diagnostics
"Diagnosis" menu
If the "Diagnosis" function is selected, the following options are displayed:
• Active faults/alarms (failures and warnings)
• History
• Identification/maintenance
• I/O status
• Status communication
• I/O simulation
• Drive enable signals
Active faults/alarms
If this option is selected, all active faults and alarms that have
not yet been confirmed will be displayed.
The individual faults and alarms can be selected. When the
INFO or OK key is pressed, an explanation of the relevant
fault or alarm is displayed.
If the INFO, OK or Esc key is pressed again, the list of faults
or alarms is displayed.
312
Inverter cabinet units
Operating Instructions, 12/2014, A5E32923362A