Siemens SINAMICS S120 Commissioning Manual page 269

Term
Measurement on
the device
(memory card)
Trace configura-
tion with the same
name in the drive
and in the project.
Principle of operation of the trace function
①
②
③
④
⑤
Figure 5-3
Data archive
The trace toolbar and the curve diagram also allow the trace configuration and the analysis
of the recording/measurement to be transferred.
The data archive is schematically shown in the following diagram:
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Icon Meaning
Measurements are archived in the folder which are saved in the de-
vice (e.g. on the memory card).
These measurements are retentive and can only be deleted by the
user. The measurements in the device can be imported into the folder
via drag and drop and thus be saved in the project as measurement.
Generally, for a trace configuration in the drive, there is also a trace
configuration of the same name in the PG project.
The signals to be recorded, the recording time and the trigger conditions are defined in the
trace configuration.
If an online connection exists, you transfer the complete trace configuration from the PG to the
device.
If the trace configuration is activated, then the recording is carried out independent of the PG.
The recording is started in the device as soon as the trigger condition has been fulfilled.
When you save the measurement, then the measurement is saved to the opened PG project.
Saving the measurement is independent of when the measurement was actually made.
After the measurement has been saved in the PG, it can be displayed and evaluated there.
From the PG, you can export the measurement data as file - and subsequently import it again.
Principle of operation
Diagnostics
5.3 Diagnostics via Startdrive
267