Smc40 Sensor Module Cabinet (Only For Direct Measuring Systems) - Siemens SINAMICS S120 Commissioning Manual

Diagnostics
5.2 Diagnostics using LEDs
LED Color
Green/ora
nge
or
Red/orang
e
OUT > 5 –
V
Orange
The parameters for activating component recognition using LEDs can be taken from the following reference:
1)
Reference: SINAMICS S120/S150 List Manual
5.2.3.4

SMC40 Sensor Module Cabinet (only for direct measuring systems)

Table 5- 23 Meaning of the LEDs on the Sensor Module Cabinet-Mounted SMC40
LED Color
RDY –
READY
Green
Orange
Red
Green/red Flashing
Green/
orange
or
Red/
orange
The parameters for activating component recognition can be taken from the following reference:
1)
Reference: SINAMICS S120/S150 List Manual
Each channel has a multifunction LED.
254
Status Description, cause
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component
recognition is activated.
Off The electronics power supply is missing or outside permis-
sible tolerance range.
Power supply ≤ 5 V.
Continu- The electronics power supply for the encoder system is
ous light available.
Power supply > 5 V
Status Description, cause
Off The electronics power supply is missing or outside the per-
missible tolerance range.
Continu- The component is ready for operation. Cyclic DRIVE-CLiQ
ous light communication is taking place.
Continu- DRIVE-CLiQ communication is being established.
ous light
Continu- This component has at least one fault.
ous light
Note:
LED is controlled irrespective of the corresponding messag-
es being reconfigured.
Firmware download is complete. The system waits for
light POWER ON.
2 Hz
Flashing Component recognition via LED is activated
light
Note:
Both options depend on the LED status when component
recognition is activated.
.
1)
.
1)
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Remedy
–
–
–
Remedy
–
–
–
Correct and
acknowledge the fault.
Carry out a POWER
ON.
–