Control Interface Module In The Power Module Chassis Format - Siemens SINAMICS S120 Commissioning Manual

LED, state
Ready DC link
Green / red ---
flashing light
2 Hz
Green / ---
orange
or
red / orange
flashing light
2 Hz
Table 5- 17 Meaning of the LED "POWER OK" on the Control Interface Module in the Motor Module
LED Color
POWER OK Green
5.2.2.11

Control Interface Module in the Power Module chassis format

Table 5- 18 Meaning of the LEDs "READY" and "DC LINK" on the Control Interface Module in the Power Module
LED, state
READY DC LINK
Off Off
Green Off
Orange
Red
Orange Orange
Red ---
Flashing ---
light
0.5 Hz:
Green / red
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
Description
Firmware download is complete. Wait for POWER ON.
Component detection using LED is activated (p0124).
Note:
Both options depend on the LED status when module recognition is activated via p0124 = 1.
State Description
Off DC link voltage < 100 V and voltage at -X9:1/2 less than 12 V.
On The component is ready for operation.
Flashing There is a fault. If the LED continues to flash after you have performed a
light POWER ON, please contact your Siemens service center.
Description
The electronic power supply is missing or lies outside the permissible tolerance range.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The DC link voltage is present.
The component is ready for operation and cyclic DRIVE-CLiQ communication is taking
place.
The DC link voltage is too high.
DRIVE-CLiQ communication is being established.
At least one fault is present in this component.
Note:
LED is controlled irrespective of the corresponding messages being reconfigured.
Firmware is being downloaded.
Diagnostics
5.2 Diagnostics using LEDs
251