Siemens SINAMICS S120 Commissioning Manual page 67

Connecting a signal
To make a connection, proceed as follows:
1. Click the binector or connector icon of the signal that you want to connect (
A connection dialog for the selection of the possible parameters opens. The drive object
for which you want to make an interconnection is displayed automatically in the "Drive
object" drop-down list on the right.
Figure 3-4
The last set signal sink is displayed in the "Selected sinks" field. If a connection was not
available previously, the text "No sink selected" is displayed.
2. Activate the check boxes for the parameters that you want to connect.
If connectable bits of the parameter are available, they are displayed in a drop-down list.
Commissioning with Startdrive
Commissioning Manual, 12/2018, 6SL3097-5AA10-0BP0
BICO dialog output
Fundamentals
3.3 BICO interconnections
or ).
65