Mitsubishi Electric Melsec Q Series Programming Manual page 325

5 OPERATION CONTROL PROGRAMS
Word devices
Setting
data
Dn Wn
(D)
(S)
(n)
[Errors]
POINT
The BMOV instruction cannot be used for the cam data write/read under the SV22
advanced synchronous control.
Use the CAMWR/CAMWR2 instruction (Cam data write) or the CAMRD instruction
(Cam data read). (Refer to Section 5.18.)
(4) The word devices that may be set at (D), (S) and (n) are shown below.
(Note-2)
SDn U \Gn #n
—
—
(5) The cam No. that may be set as "Nn" is within the following range.
Q173D(S)CPU/Q172D(S)CPU
1 to 64
101 to 164
201 to 264
301 to 364
(1) An operation error will occur if:
• The cam data of cam No. specified with (D) or (S) are not yet registered to the
Motion controller
• The resolution of cam No. specified with (D) or (S) differs from the number of
transferred words specified with (n)
• (S) to (S)+(n-1) is outside the device range
• (D) to (D)+(n-1) is outside the device range
• (n) is 0 or a negative number
• PX/PY is set in (S) to (S)+(n-1)
• PX/PY is set in (D) to (D)+(n-1)
(2) When conversion of Motion SFC program is made in MT Developer2, an error will
occur if:
• (S) to (S)+(n-1) is outside the device range
• (D) to (D)+(n-1) is outside the device range
• (n) is 0 or a negative number
• PX/PY is set in (S) to (S) + (n-1)
• PX/PY is set in (D) to (D) + (n-1)
• (S) is a bit device and the device number is not a multiple of 16
• (D) is a bit device and the device number is not a multiple of 16
QDS
Bit devices
Mn U \Gn.m Bn
—
—
— — —
(Note-1) : "Nn" indicates the cam No.
(Note-2) : The device No. cannot be specified indirectly.
(Note-3) : Specify a multiple of 16 as the device number of bit data.
(Note-4) : PX/PY cannot be set.
5 - 102
(Note-2), (Note-3)
Fn SMn Xn Yn
—
(Note-4) (Note-4)
(Note-4) (Note-4)
— — — —
when (n) specified is a
word device
when (n) specified is a
constant
Cam No.
specification
(Note-1)
Nn
—