ABB Relion 670 Series Applications Manual page 193

1MRK 511 401-UUS F
No. StartMode
12 LatchedStart
13 FollowStart
14 FollowStart
15 FollowStart
16 FollowStart&
Mode
17 FollowStart&
Mode
18 FollowStart&
Mode
No. StartMode
FunctionMode = Current or CB Pos
19 LatchedStart
20 LatchedStart
Table continues on next page
Bay control REC670
Application manual
RetripMode t1 and t2 initiated
with
Always external START
Off external START
UseFunctionM external START
ode
Always external START
Off external START
and CBCLDLx
input has logical
value one
UseFunctionM external START
ode and CBCLDLx
input has logical
value one
Always external START
and CBCLDLx
input has logical
value one
RetripMode t1 and t2 initiated
with
Off external START
UseFunctionM external START
ode
© Copyright 2017 ABB. All rights reserved
When t1 has elapsed, When t2 or t2MPh
TRRET will has elapsed, TRBU
will be given if
always be given CBCLDLx input has
logical value one
never be given CBCLDLx input has
logical value one
be given if CBCLDLx input has
CBCLDLx input has logical value one
logical value one
if external START is CBCLDLx input has
present logical value one
never be given be given if
CBCLDLx input has
logical value one
and external START
is present
be given if be given if
CBCLDLx input has CBCLDLx input has
logical value one logical value one
and external START and external START
is present is present
be given if external be given if
START is present CBCLDLx input has
logical value one
and external START
is present
When t1 has elapsed, When t2 or t2MPh
TRRET will has elapsed, TRBU
will be given if
never be given current is above set
level *) and higher
than I>BlkCBPos or
CBCLDLx input has
logical value one
when current is
smaller than
I>BlkCBPos
be given if current current is above set
is above set level of level *) and higher
IPh> and higher than I>BlkCBPos or
than I>BlkCBPos or CBCLDLx input has
CBCLDLx input has logical value one
logical value one when current is
when current is smaller than
smaller than I>BlkCBPos
I>BlkCBPos
Section 8
Current protection
t1 and t2 and t2MPh
will be stopped
(reset) if
t1 and (t2 or
t2MPh) and 150ms
expires and
CBCLDLx input has
logical value zero
external START
disappears
external START
disappears
external START
disappears
CBCLDLx input has
logical value zero
or external START
disappears
CBCLDLx input has
logical value zero
or external START
disappears
CBCLDLx input has
logical value zero
or external START
disappears
t1 and t2 and t2MPh
will be stopped
(reset) if
t1 and (t2 or
t2MPh) and 150ms
expires and
current is below
set level *) or
CBCLDLx input has
logical value zero
t1 and (t2 or
t2MPh) and 150ms
expires and
current is below
set level *) or
CBCLDLx input has
logical value zero
187