NEC Electra Elite IPK II Programming Manual page 127

Document Revision 1
Item
No.
07
08
09
10
11
12
13
2 - 92
Item
DP to DTMF Conversion Options
Determine how a user can convert a
Dial Pulse (DP) call to a DTMF call. For
each trunk, set the type of DP to DTMF
conversion required. There are three
conversion options: Automatic (0),
Automatic and Manual (1), or Manual
(2).
Automatic:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit. In addition, the
user can dial # to switch a DP trunk to
DTMF dialing.
Manual:
User can dial # to switch a DP trunk to
DTMF dialing
Answering Condition
Busy Tone Detection
Caller ID
Enable or disable a trunk to receive
Caller ID information.
Next Trunk in Rotary if No Dial Tone
Use this option to enable/disable the
system's ability to skip over a trunk if
dial tone is not detected. This option
pertains to calls placed using Speed
Dial, ARS, Last Number Redial or
Save Number dialed. It does not
pertain to line key or Direct Trunk
Access calls.
Detect Network Disconnect Signal
Trunk-to-Trunk Limitation
Input Data
0 = Automatic
1 = Automatic and Manual
2 = Manual
0 = Polarity Reversing
(Polarity)
1 = Polarity Reversing on
Timer (Int Digit)
0 = Disable (No)
1 = Enable (Yes)
0 = No
1 = Yes
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
0 = Disable (No)
1 = Enable (Yes)
Program 14 : Trunk, Basic Setup
Electra Elite IPK II
Related
Default
Program
2 21-01-03
1 21-01-03
0
0
0
1
0