Dial Analysis Table For Ars/F-Route Access - NEC Electra Elite IPK II Programming Manual

Document Revision 1
Level:
IN
Description
Use
Pre-Transaction Table for selecting ARS/F-Route.
Input Data
Item
No.
01
02
2 - 394
Program 44 : ARS/F-Route Setup

44-02 : Dial Analysis Table for ARS/F-Route Access

Program 44-02 : Dial Analysis Table for ARS/F-Route Access
Dial Analysis Table Number
Dial
Set the number of digits to be analyzed by the
system for ARS routing.
Service Type
Service Type 1 (Extension Number)
H
The number goes to an extension after
deleting the front digit(s).
Additional Data
Assign the digit(s) to be deleted on top of the
number for extension number usage. There
must be at least one digit deleted.
Service Type 2 (ARS/F-Route)
H
The number is controlled by ARS/F-Route
table.
Additional Data:
If the ARS/F-Route Time Schedule is not
used, assign the ARS/F-Route table number
for Program 44-05.
If the ARS/F-Route Time Schedule is used,
assign the ARS/F-Route selection number for
Program 44-04.
Service Type 3 (Dial Extension Analyze Table)
H
The total length of the number exceeds more
than 8 digits.
Additional Data:
Assign the Dial Extension Analysis Table
number to be used in Program 44-03.
Item
Electra Elite IPK II
to set the
1~120
Input Data
Up to 8 digits
(Use line key 1 for a "Don't Care"
digit, @)
0 = No setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Analyze
Table (Option)
Program 44 : ARS/F-Route Setup
Default
No
Setting
0