Trunk Access Code - NEC Electra Elite IPK II Programming Manual

Electra Elite IPK II
Level:
IN
Description
Use
The trunk access code can be set from 1 to 8 digits which is defined to type 3 and 4 in
Program 11-01. This is the code extension users dial to access Automatic Route
Selection. The Individual Trunk Access Code is used when Trunk Group Routing is
desired for an outgoing line.
Input Data
Item
No.
01
Electra Elite IPK II Programming Manual
Program 11 : System Numbering
Program 11-09 : Trunk Access Code
The digit 9 is defined in Program 11-01 as Dial Type 3 with the Number of Digits
Required set to 1. If you change the trunk access code in Program 11-09, you
must make the corresponding changes in Program 11-01.
Item Input Data
Trunk Access
Code
(up to 4

11-09 : Trunk Access Code

to assign the trunk access code (normally 9).
Caution!
Default
Dial 9
digits)
Document Revision 1
Description Related Program
Use this program 11-01 : System
H
Numbering
to assign the trunk
access code
14-01 : Trunk Basic
H
(normally 9). This
Data Setup
is the code
14-05 : Trunk Group
extension users
H
dial to access
14-06 : Trunk Group
H
Automatic Route
Routing
Selection.
2 - 47